| Borosilicate protective glass |
| T5 replacement ballast 54w 110v/60hz |
| Giesemann Electronic ballast HQI 250w |
| Giesemann Electronic ballast HQI 150w |
| Wall bracket 24 inche
 |
It is not always convenient to suspend a pendant from the ceiling. As an alternative, these brackets can be attached to the wall behind the aquarium. The arms of the bracket extend out above the aquarium, and the pendant can be suspended from any one of the mounting points. These brackets are available in the 6 standard colours of our lightings. |
|
| Giesemann T5 waterproof end-caps (4 pieces)
|
| Giesemann FC-2 250w - 400w HQI Ceramic socket
|
| Giesemann RX-7 150w HQI Ceramic socket |
| High polished T5 reflector made in Germany 99.8%
 When a fluorescent tube is fixed over an aquarium, any rays emitted from the top half of the tube are directed away from the water, and are wasted.
By using a suitable reflector on the tube, it is possible to obtain the maximum efficiency from the tube, because this otherwise lost light energy is redirected to where it is required, into the aquarium.
The GIESEMANN reflectors are manufactured from sturdy corrosion resistant high glossy aluminium, and the design is such that they can easily be mounted to the aquarium hood. The reflector has a unique Gull Wing shape which is designed to avoid, as far as possible, the light reflecting back through the tube therefore resulting in maximum light output and minimum waste of energy.
It is possible to tilt the reflector so the light can be directed according to preference without any loss of light output. Depending on your output requirements the reflectors are available for use with 550 mm, 850 mm, 1150 mm and 1450 mm (T-5 / T-8 ) with a choice of 24, 39, 54 or 80 watts.
Models:
- |
24w High polished T5 reflector made in Germany 99.8%
20 inche |
- |
39w High polished T5 reflector made in Germany 99.8%
30 inche |
- |
54w High polished T5 reflector made in Germany 99.8%
40 inche |
- |
80w High polished T5 reflector made in Germany 99.8%
50 inche |
|
